i find it cool

i dont like the handguards btw..

I find inaccurate for the stock upper and lower curves, and also the butt plate used in which Boyi Rk06 far more correct. but can fix using butt rubber pad.

lower handguard curve seems too ugly
But can also remedied by attaching Grenade launcher

My reference: http://tantal.kalashnikov.guns.ru/variants.html

Well, I like it to be weathered...as usual..., scratch with tender , beat a little love and burn with care...

@komrad Blaze:
Just be careful with the rear sling attachment, better wrap a paracord at front end of buttstock for sling attachment. Use only the original sling attachment for photo-ops

Me too. Looks more modern

Update ko lang, After the game today, the AK had some issues:
•Hop-up was hard to adjust(.20 proved to light)
•Some of the Rivets on the receiver became loose, making
the whole front end and the scope mount wobble.

I already fixed the Hop-up issue by replacing with a systema hop bucking
and an SCS. But the rivet part seems tricky; Is there a tool that could let me
tighten it up?

ngak... better open it up.. screw on the scope mount can be tightened inside the receiver once the gearbox has been removed.. you can also check the rivets in this way..

bring it to a professional machine shop for them to tighten the pins and rivets..

it seems Kalash is more solid than CYMA heheheh

I was just playing around with the Hop-up when I realized that the Stock
Hop-Up Rubber is a V-Type Hop-up. The Hop-up part that pushes the nub
is not molded right, When I installed the SCS, I noticed that It was leaning to the right,
I filed it down to level it.

how bout pins and rivets? musta na?

Hindi ko pa naaayos, masyado busy kasi eh, araw-araw entrance review.
subukan ko this weekend, sana magawa na.

My cm048m is now dead after about 150 rounds its not working any more. Its not the fuse. Can it be the motor?

could be..

it could be the wiring, or switch assembly.. try it with an ohmmeter or a continuity tester if you have one

check also all the connector plug(from battery to fuse to motor)
try also use other batt

Because of the looks as well as initial reviews on the 048M, i also bought one from Tuks's.

My problems are:

1. magazine misfeeding using both jg and cyma mags. (am using lipoly could it be solved by a sector delayer?)
2. front and rear lip of the mag well. I had to dismantle the gun numerous times because magazine jam when inserting. i cannot remove the magazine because the lid where you put the bbs open up inside the mag well and force pulling it might damage either the mag well or the magazine. btw, both jg and cyma mags work perfectly with my jg spetz

BTW, modifications on the gun are:
1. EDGI 6.01 TB
2. SCS
3. Rewired for an evo mosfet

It was one of the wires that was in a bad place

Oversized na yung tappet post ng Sector gear sa 048 kaya d pwede lagyan ng sector chip, kung sakali mapalitan ito ng regular gear para malagyan ng sector chip.

I never experienced misfeeding with my magazine, pero magkaiba kasi magazine nung 048 sa 048M.

Tumgil din umandar yung AK 74 ko dati, naging problema yung nag ka low bat tapos nag half crank lang yung gearbox, parang sumabit yung cut-off lever kaya hindi umaabot yung kuryente sa motor.

good to know it's ok now komrad...