Unlock to open the top(dust) cover.


Carefully hold the cover while opening it, take note the correct angle(Blue arrow).
If you swing it freely then It may damage the stopper(Yellow arrow), Loosen the Hinges pin(Red arrow) and the Hinges itself(Green arrow).
Take note also the pin(White arrow) that hold and lock the upper Handguard.

At this point you can disassemble the Handguard, though optional.

Just be extra careful not to bend the dust cover.


detached upper handguard.


for lower Handguard...check the lever lock(Yellow arrow), take note the position.


Turn the lever to unlock the lower Handguard.


Carefully detach the lower handguard.

Note for upper Handguard Assembly...

Take extra care with the handguard ring(arrow) to prevent damage.

Now for Front end disassembly.

Just like TM, take out the four screws but again careful not to loosen the thread of front end assembly.



CYMA AKSU is Marui clone except the front end.
The rest of procedure is here: TM AK47 Disassembly Procedure

For references:
FilAKairsoft Shakedown and komrad Stan CYMA AKSU Review

*all images are clickable for large files

For Hop up disassembly, proceed here

very nice komrad. mukhang sticky eto

Sticky

katas ng lessons learned

goodah.

nga pala if i may add my cm035 lower handguard lock broke dahil masyado masikip yung nakuha ko. Brittle pala sha so ingat. Have to use pliers to turn the lock now. pag pati yung natitirang pde gamitan ng pliers masira ko pa rin, ska nku papa fabricate ng replacement hehe.

thanks for the info kom laughingstorm

Mga comrades question lang, will the wood-type plastic pistol grip from a Cyma CM.028 fit into a Cyma CM.035 and vice-versa will the black plastic grip from the CM.035 fit the CM.028? If I could acquire a used CM.035 (soon na sana), gusto kong i-match ang wood-type pistol grip with the wood-type handguard nito.

YES komrad....a little precision modification...


just cut the pistol grip extension(?) carefully dahil magamit eto.
Gamit ka ng manipis na lagare komrad...
Then connect mo eto sa "wood" grip...

(not an actual image)

and be sure to check the alignment tabs on both units, komrad.


035 pistol grip on the left

my bad...i missed that tab ...

understandable, komrad bulilit kasi sya kaya madalas hindi masyado napapansin

kaya pa rin kung tiyagain mo ng bulak at super glue then sandpaper to make artficial tabs.

mga komrad, pwede ba na yung metal body cyma na may folding stock lagyan ng JG tactical na front assembly? minimal mods lang ba to?

konting kayas lang, if ever